Fault and repair guide
Stops in play or recordThe first thing to check is that there is adequate torque on the take up spool. If there isn't much then the cause is usually down to two contributing factors.
The first is the drive pendulum which can cease up and the second, and the second more serious factor, is wear on the reel motor bottom bearing. The pendulum is simple to replace but the bearing is moulded into the chassis and replacement necessitates that the entire chassis be replaced. One possible compromise is to fit a small piece of plastic into the bottom bearing to raise the rotor and allow it to move freely. Sony supply a repair kit for this purpose.
No head drum rotationYou may find that the head drum fails to rotate. This is due to a problem with the Hall effect device on the head drum motor which is secured by a blob of glue. Full details on how to fix this can be found on the head motor page.
Deck goes into rewindThis can be caused by failure of the tape end sensor. You can check this by unplugging the sensor at its socket on the PCB.
Failure to load a tapeThe cassette carriage can fail to operate. This is caused by breakage of the plastic gears in the side of the mechanism. When this happens they have to be replaced.
Loading gear and shaft repairThe loading shaft for the Sony has no official replacement but most times it can be repaired, unless the gear is in two pieces or a tooth has broken off. There are two approaches to solve this, either repair the broken gear, or purchase a similar gear and adapt it to fit.
In practice the diameter is sufficient and the reduced length does not really matter, just use super glue (or other suitable glue) to glue them to the shaft and protrude the shaft 1mm or so past the end.
See: RC-Toy-Car gears
If you don't need 50 then look for a smaller quantity but the price does not seem to change much.
Quick fault guidePlease click on the button if you are able to contribute a solution to this list or would like to add to, or update PALsite's information on this model.
If you have a question about this model, please raise it on the chatpage.
|Ever power on but the display change when pulse on/stand by, not load the tapes||Before of this problem played in b/w with some short white lines
I checked the voltages of the power supply in on and in stand by and all was correct except the 12 volts output, pin 9 of IC001 (STK 5441) and pin 2 of CN002 that ever had about 20 volts
I changed the IC001 (STK 5441) and now load and play in b/w with some short white lines
Is rare that the fuses was not cutted and the video was not damage